The keypad (526-0099-xx) fastens to the inside of the top case. The assembly includes the keypad ECA,
the key set, and the keypad cable. The individual pieces remain together when you remove the keypad.
1 Remove the following items:
Front bezel and front bezel vent (see page 13)
Focus and zoom rings (see page 11)
Top case (see page 20)
2 Place the top case face down on the work surface.
3 Remove the two black M3x6 Plastite Torx screws that fasten the keypad to the top case, and then
lift the keypad and cable out.
Assembly Notes
♦ When you install the keypad, make sure that the alignment pins in the top case fit into the holes at
each end of the keypad ECA.
♦ Torque the two black M3x6 Plastite Torx screws to 4 in.-lbs. (.452 Nm).